1. Configure TRESPA - Laboratory Countertops:

TRESPA TOPLAB PLUS SOLID PHENOLIC LABORATORY TOPS

Material: Solid phenolic panel

Modulus of Elasticity: 1,305,000 psi (9,000 N/sqmm) minimum

Tensile Strength: 10,150 psi (70 N/sqmm) minimum

Flexural Strength: 14,500 psi (100 N/sqmm) minimum

Porosity: Nonporous surface and edges

Microbial Characteristics: Will not support microorganic growth

Chemical Resistance: Provide solid phenolic panel providing minimum performance when tested for chemical resistance in accordance with SEFA 8 (Laboratory Casework)

Dimensions: SELECT THICKNESS-------1/2 inch (13 mm)5/8 inch (16 mm)3/4 inch (19 mm)1 inch (25 mm)As noted on the Contract Drawings

Finish: SELECT COLOR-------As Specified in the Finish Schedule of the Contract DocumentsMystic White T18.0.1White T03.0.0Pastel Grey T03.1.0Polar Green T30.0.1Limestone Yellow T05.0.1Silver Grey T03.4.0Glacier Blue T21.1.1Canyon Red T09.3.4Black T90.0.0Speckled - Mystic White/Blue D02.0.8Speckled - Limestone Yellow/Saffron D02.0.9Speckled - Pastel Grey/Silver D02.1.0

ACCESSORIES

Laboratory Shelving: Provide solid phenolic laboratory shelving where indicated on the Contract Drawings

Pegboards: Provide solid phenolic pegboards where indicated on the Contract Drawings

Reagent Racks: Provide solid phenolic reagent racks where indicated on the Contract Drawings

Installation Materials: Provide solid phenolic laboratory top manufacturer's joint adhesive, panel adhesive and sealants as required to suit project conditions

FABRICATION

Fabricate solid phenolic laboratory tops and accessory items: SELECT GRADE-------Comply with requirements of AWI Custom gradeComply with requirements of AWI Premium grade

Edge Treatment: SELECT TYPE-------As indicated on the Contract DrawingsChamfer or radius edge and drip grooveCrescent edgeStandard edge (chamfer) or radius 1/16 inch (2mm)Type: _______________

Joints: SELECT TYPE-------As indicated on the Contract DrawingsAs selected from the manufacturer's available joint optionsTight joint with spline and chamferTight joint with spline and sealant - recommended for hygienic applicationsTight joints with splineType: _______________

Sink cut outs: SELECT TYPE-------As indicated on the Contract DrawingsAs selected from the manufacturer's available joint optionsGroove for undermount sinkRouted for drop in sinkSink cut out with lid, edge with drip groove fro undermount sinkType: _______________

2. When you are finished making selections:

Generate Spec: Word     WP   or   RTF